apr08 data production
Data and joblog are at
- E-log of MC Production
( username/password for viewing only is mcprod/ildmc )
File name convension
The general format of the generated file names are as follows:
- type is an event type.
- geom is a geometry name. Actual geometry file name
- numevents is the number of events contained in this file.
- seq is a serial number attached to the file
created with a same condition except rundom seeds.
Following event types are used.
- Single gamma
Single gamma events, generated uniformly in cosTheta and Phi from IP.
Its format is [single-particle_kinetic-energy]. kinetic-energy in a unit of GeV/c.
- Single muminus
Single muminus events, generated uniformly in Phi(Azimuthal angle) at
fixed cosTheta and Kinetic energy from the coordinate, (x,y,z)=(0.0,0.0,0.05m).
Its format is
[single-particle_kinetic-enegy_cs0pvalues-after-decimal-point]. kinetic-energy is in a unit of GeV/c.
e+e-→q qbar events with ISR turned off,
where q is u-quark, d-quark, or s-quark.
The format is [udsECM], where
ECM is a center of mass energy in GeV.
If ECM=91, it is 91.17 or 91.18 depending on when it is simulated.
Please check the corresponding log file.
e+e-→Z Z events, including all Z decay mode.
Beamstrhlung and ISR are tunred on. nominal 350 GeV beam parameter
and 0.1% full width initial beam spread is used for the beamstrahlung spectrum.
e+e-→Z Z events, where one Z decays to
neutrino pair and the other to quarks. Input generator data file is
beamstrahlung condition is nominal 350 GeV with 0.1% full width initial energy